Inspiron 14 5410 Service Manual

PDF

Removing the display assembly

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Enter Service Mode.
  3. Remove the base cover.

About this task

The following image(s) indicate the location of the display assembly and provides a visual representation of the removal procedure.

Removing the display assembly

Removing the display assembly

Steps

  1. Peel the tape that secures the display-cable connector latch to the system board.
  2. Lift the latch and disconnect the display-cable from the connector on the system board.
  3. Remove the two screws (M2.5x4) that secure the right-display hinge to the system board.
  4. Pry open the right-display hinge at an angle of 90 degrees.
  5. Remove the two screws (M2.5x4) that secure the left-display hinge to the I/O board.
  6. Pry open the left-display hinge at an angle of 90 degrees.
  7. Gently lift the palm-rest and keyboard assembly off the display assembly
    CAUTION To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\