Inspiron 14 5410 Service Manual
Removing the heat sink
Prerequisites
- Follow the procedure in Before working inside your computer.
- Enter Service Mode.
- Remove the base cover.
About this task
CAUTION The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you touch it.
NOTE For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The oils in your skin can reduce the heat transfer capability of the thermal grease.
The following image(s) indicate the location of the heat sink and provides a visual representation of the removal procedure.
Steps
- In reverse sequential order (7>6>5>4>3>2>1) loosen the seven captive screws that secure the heat sink to the system board.NOTE The number of screws varies depending on the configuration ordered.
- Lift the heat sink from the system board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\