Inspiron 14 5410 Service Manual

PDF

Removing the I/O board

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Enter Service Mode.
  3. Remove the base cover.

About this task

The following image(s) indicate the location of the I/O board and provides a visual representation of the removal procedure.

Removing the I/O board

Steps

  1. Remove the two screws (M2.5x4) that secure the left-display hinge to the I/O board.
  2. Pry open the left-display hinge at an angle of 90 degrees.
  3. Lift the I/O-board cable-connector latch and disconnect the I/O-board cable from the I/O board.
  4. Lift the power-button with fingerprint-reader cable-connector latch and disconnect the power-button with fingerprint-reader cable from the I/O board.
    NOTE This step is only applicable for computers shipped with the optional fingerprint reader.
  5. Remove the screw (M2x3) that secures the I/O board to the palm-rest and keyboard assembly.
  6. Disconnect the coin-cell battery cable from the I/O board.
  7. Lift the I/O board off the palm-rest and keyboard assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\