Inspiron 14 5410 Service Manual

PDF

Removing the M.2 2230 solid-state drive

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Enter Service Mode.
  3. Remove the base cover.

About this task

NOTE This procedure applies only to computers shipped with an M.2 2230 solid-state drive installed.
NOTE The M.2 card installed on your computer will depend on the configuration ordered. Supported card configurations on the M.2 card slot:
  • M.2 2230 solid-state drive
  • M.2 2280 solid-state drive

The following image(s) indicate the location of the M.2 2230 solid-state drive and provides a visual representation of the removal procedure.

Removing the M.2 2230 solid-state drive

Steps

  1. Remove the screw (M2x3) that secures the M.2 2230 solid-state drive to the system board.
  2. Slide and lift the M.2 2230 solid-state drive off the system board.
  3. Slide and lift the M.2 2230 solid-state drive off the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\