Inspiron 14 5410 Service Manual

PDF

Removing the palm-rest and keyboard assembly

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the 3-cell battery or the 4-cell battery, whichever applicable.
  4. Remove the coin-cell battery.
  5. Remove the M.2 2230 solid-state drive.
  6. Remove the M.2 2280 solid-state drive.
  7. Remove the wireless card.
  8. Remove the power-adapter port.
  9. Remove the I/O board.
  10. Remove the speakers.
  11. Remove the touchpad.
  12. Remove the fan.
  13. Remove the display assembly.
  14. Remove the power-button with optional fingerprint reader.
  15. Remove the system board.
    NOTE The system board can be removed with the heat sink and solid-state drives attached.

About this task

The following image(s) indicate the location of the palm-rest and keyboard assembly and provides a visual representation of the removal procedure.

Removing the palm-rest and keyboard assembly

Steps

After performing the pre-requisites you are left with the palm-rest and keyboard assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\