Precision 3640 Tower Service Manual

PDF

Installing the 2.5-inch hard drive

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following images indicate the location of the 2.5-inch hard drive and provides a visual representation of the installation procedure.

Installing the 2.5-inch hard driveInstalling the 2.5-inch hard drive

Steps

  1. Align the securing pins in the hard drive bracket with the pits on the 2.5-inch hard drive.
  2. Firmly press the 2.5-inch hard drive into the bracket until it clicks in place.
  3. Replace the hard drive assembly into the hard drive bay and press it firmly into the slot.
  4. Connect the power and data SATA cables to the 2.5-inch hard drive.

Next steps

  1. Install the cover.
  2. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\