Precision 3640 Tower Service Manual

PDF

Installing the optical drive

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following images indicate the location of the optical drive and provides a visual representation of the installation procedure.

Installing the optical drive

Steps

  1. Slide the optical drive into the drive bay from the front of the computer until it is secured.
  2. Connect the data cable and power cable to the optical drive.

Next steps

  1. Install the bezel.
  2. Close the psu hinge.
  3. Install the cover.
  4. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\