Precision 3640 Tower Service Manual

PDF

Installing the optional IO card

Steps

  1. To remove the metal bracket as shown below, insert a flathead screwdriver in the hole of the bracket [1], push the bracket to release the bracket [2], and then lift the bracket out from the system.
    Removing the metal bracket
  2. Insert the IO card into its slot from the inside of your computer [1] and replace the two M3X3 screws to secure the IO card to the system [2].
  3. Connect the IO card cable to the connector on the system board [3].
    Placing the VGA module into the slot
  4. Close the PSU hinge.
  5. Install the Cover.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\