Precision 3640 Tower Service Manual

PDF

Installing the power button module

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following images indicate the location of the power button module and provides a visual representation of the installation procedure.

Installing the power button module

Steps

  1. Insert the power button module into its slot on the system and press the notches and secure it to the system.
  2. Affix the adhesive tape to secure the power button module to the system.
  3. Route the power button module cable through the routing clips on the system.
  4. Connect the power button module cable to the connector on the system board.

Next steps

  1. Install the IO panel.
  2. Install the bezel.
  3. Close the psu hinge.
  4. Install the cover.
  5. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\