Precision 3640 Tower Service Manual

PDF

Installing the speaker

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image indicate the location of the speaker and provides a visual representation of the installation procedure.

Installing the speaker

Steps

  1. Replace the speaker into its slot in the chassis and slide it until it clicks in place.
  2. Tuck the cable along the routing guide on the system board and connect the speaker cable to the system board.

Next steps

  1. Close the psu hinge.
  2. Install the cover.
  3. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\