Vostro 5402 Service Manual

PDF

Installing the DC-in port - discrete

About this task

The figure indicates the location of the DC-in and provides a visual representation of the removal procedure.

Installing DC-in port - discrete

Steps

  1. Place the DC-in port on the palm-rest and keyboard assembly.
  2. Replace the single screw (M2x3) on the DC-in port using bracket.
  3. Connect the DC-in cable to the system board.
  4. Adhere the transparent sticker.
  5. Lower the metal hinge.
  6. Replace the two (M2.5x4) screws, and tighten it.

Next steps

  1. Install the battery (3-cell or 4-cell) based on the configuration.
  2. Install the base cover.
  3. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\