Vostro 5402 Service Manual

PDF

Installing the display assembly - discrete

Prerequisites

CAUTION: The maximum operating angle for the display-panel hinge is 135 degrees.

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the location of the component and provides a visual representation of the installation procedure.

Installing the display assembly - discrete

Connect the display cable on to the connector

Steps

  1. Place the display assembly on a clean and flat surface.
  2. Align and place the palm-rest and keyboard assembly on the display assembly.
  3. Using the alignment posts, close the display hinges.
  4. Replace the two screws (M2.5x4) and (M2x3) that secure the left-display hinge to the system board.
  5. Replace the two screws (M2.5x4) that secure the right-display hinge to the system board.
  6. Connect the display cable on to the connector on the system board and adhere the tape to the system board.

Next steps

  1. Install the WLAN card.
  2. Install the battery 3-cell or 4-cell.
  3. Install the base cover.
  4. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\