Vostro 5402 Service Manual

PDF

Installing the memory modules - UMA

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the location of the memory module and provides a visual representation of the installation procedure.

Installing memory modules - UMA

Steps

  1. Lift the mylar, and align the notch on the memory module with the tab on the memory-module slot.
  2. Slide the memory module firmly into the slot at an angle.
  3. Press the memory module down until it clicks into place.
    NOTE: If you do not hear the click, remove the memory module and reinstall it.

Next steps

  1. Connect the battery (3-cell or 4-cell) based on the configuration.
  2. Install the base cover.
  3. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\