Vostro 5402 Service Manual

PDF

Installing the palm-rest and keyboard assembly - discrete

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the location of the palm-rest and keyboard assembly and provides a visual representation of the installation procedure.

Palmrest and keyboard assembly - discrete

Steps

Place the palm-rest and keyboard assembly on a flat surface.

Next steps

  1. Install the system board.
  2. Install the touchpad.
  3. Install the DC-in port.
  4. Install the power button with fingerprint reader.
  5. Install the I/O board.
  6. Install the coin-cell battery.
  7. Install the heat sink.
  8. Install the display assembly.
  9. Install the speakers (3-cell battery configuration or 4-cell battery configuration).
  10. Install the system fan.
  11. Install the SSD-1 (M.2 2230 SSD card or M.2 2280 SSD card).
  12. Install the SSD-2 .
  13. Install the memory modules.
  14. Install the WLAN card.
  15. Install the battery (3-cell or 4-cell) based on the configuration.
  16. Install the base cover.
  17. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\