Vostro 5402 Service Manual

PDF

Installing the speakers (in 4-cell battery configuration)

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the location of the speakers in a system configuration with 4-cell battery and provides a visual representation of the installation procedure.

Installing speakers - discrete

Steps

  1. Using the alignment posts and rubber grommets, place the speakers in the slots on the palm-rest and keyboard assembly.
  2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
  3. Connect the speaker cable to the system board.

Next steps

  1. Install the system board (UMA or discrete).
  2. Install the battery (3-cell or 4-cell) based on the configuration.
  3. Install the base cover.
  4. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\