Vostro 5402 Service Manual

PDF

Installing the system fan - UMA

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the location of the system fan and provides a visual representation of the installation procedure.

Installing system fan - UMA

Steps

  1. Slide and place the system fan on the palm-rest and keyboard assembly.
  2. Align the screw holes on the system fan with the screw holes on the palm-rest and keyboard assembly.
  3. Replace the two (M2x2) screws to secure the system fan to the palm-rest and keyboard assembly.
  4. Connect the system fan cable to the system board.
  5. Route the I/O cable underneath the system fan and connect it to the system board.
  6. Place the mylar cover back.

Next steps

  1. Install the battery (3-cell or 4-cell) based on the configuration.
  2. Install the base cover.
  3. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\