Vostro 5402 Service Manual

PDF

Installing the WLAN card - discrete

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the location of the WLAN card and provides a visual representation of the installation procedure.

Intalling the WLAN card - discrete

Steps

  1. Align the notch on the WLAN card with the tab on the WLAN card slot and insert the WLAN card at an angle into the WLAN card slot.
  2. Connect the antenna cables to the WLAN card.
  3. Align and place the WLAN card bracket on the WLAN card.
  4. Replace the screw (M2x3) to secure the WLAN card bracket to the WLAN card.

Next steps

  1. Install the battery (3-cell or 4-cell) based on the configuration.
  2. Install the base cover.
  3. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\