Vostro 16 5630 Owner's Manual
Installing the heat sink for computers shipped without a discrete graphics card
Prerequisites
CAUTION:The information in this section is intended for authorized service technicians only.
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the heat sink and provides a visual representation of the installation procedure.
Steps
- Align the captive screws on the heat sink to the screw holes on the system board.
- In sequential order (1>2>3>4), tighten the four captive screws that secure the heat sink to the system board.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\