Vostro 16 5630 Owner's Manual

PDF

Installing the I/O board

Prerequisites

CAUTION:The information in this section is intended for authorized service technicians only.
If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the I/O board and provides a visual representation of the installation procedure.

Installing the I/O board

Steps

  1. Align the screw holes on the I/O board with the screw holes on the system board and palm-rest and keyboard assembly.
  2. Align the ports on the I/O board with the slots on the palm-rest and keyboard assembly.
  3. Place the I/O board on the palm-rest and keyboard assembly.
  4. Replace the two screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly.
  5. Connect the I/O-board cable to the I/O board.
  6. Close the latch and replace the clear adhesive tape.
  7. Connect the fingerprint-reader cable to the I/O board and close the latch to secure the cable.
  8. Align the screw holes on the RJ45 network-port assembly with the screw holes of the I/O board.
  9. Replace the three screws (M2x5) that secure the RJ45 network-port assembly to the I/O board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\