Vostro 16 5630 Owner's Manual

PDF

Installing the palm-rest and keyboard assembly

Prerequisites

CAUTION:The information in this section is intended for authorized service technicians only.
If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the palm-rest and keyboard assembly and provides a visual representation of the installation procedure.

Installing the palm-rest and keyboard assembly

Steps

Place the palm-rest and keyboard assembly on a flat and clean surface and perform the post-requisites to install the palm-rest and keyboard assembly.

Next steps

NOTE: The system board can be removed and installed along with the heat sink, when you replace the palm-rest and keyboard assembly. This simplifies the removal and installation procedure and also prevents damage to the thermal bond between the system board and heat sink.
  1. Install the touchpad.
  2. Install the system board.
  3. Install the tpm board.
  4. Install the display assembly.
  5. Install the power adapter port
  6. Install the power button with optional fingerprint reader.
  7. Install the I/O board.
  8. Install the coin-cell battery.
  9. Install the speakers.
  10. Install the battery.
  11. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive, whichever applicable.
  12. Install the wireless card.
  13. Install the fan.
  14. Install the base cover.
  15. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\