Vostro 16 5630 Owner's Manual
Installing the power-adapter port
Prerequisites
CAUTION:The information in this section is intended for authorized service technicians only.
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the power-adapter port and provides a visual representation of the installation procedure.
Steps
- Place the power-adapter port into the slot on the palm-rest and keyboard assembly.
- Connect the power-adapter port cable to the system board.
- Adhere the tapes that secure the power-adapter port cable to the system board.
- Close the right display hinge and align the screw holes on the right display hinge with the screw holes on the system board.
- Replace the three screws (M2.5x5) that secure the right display hinge to the system board.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\