Vostro 16 5630 Owner's Manual

PDF

Removing the battery

Prerequisites

CAUTION:The information in this section is intended for authorized service technicians only.
  1. Follow the procedure in Before working inside your computer.

About this task

NOTE:Before removing the base cover, ensure that there is no SD card installed in the SD card slot on your computer.

The following image(s) indicate the location of the battery and provides a visual representation of the removal procedure.

Removing the battery

Steps

  1. Peel the tape that secures the battery cable to the battery
  2. Disconnect the battery cable and disengage it from the tabs on the system board.
  3. Remove the five screws (M2x3) that secure the battery to the palm-rest and keyboard assembly.
  4. Lift the battery off the palm-rest and keyboard assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\