Vostro 16 5630 Owner's Manual

PDF

Removing the display assembly

Prerequisites

CAUTION:The information in this section is intended for authorized service technicians only.
  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.

About this task

NOTE:Before removing the base cover, ensure that there is no SD card installed in the SD card slot on your computer.

The following image(s) indicate the location of the display assembly and provides a visual representation of the removal procedure.

Removing the display assembly

Steps

  1. Remove the three screws (M2.5x5) that secure the left display hinge to the system board.
  2. Open the left display hinge at an angle of 90 degrees.
  3. Remove the three screws (M2.5x5) that secure the right display hinge to the system board.
  4. Open the right display hinge at an angle of 90 degrees.
  5. Peel the tape that secures the display-cable connector latch to the system board.
  6. Open the latch and disconnect the display cable from the system board.
  7. Remove the display cable from the routing guides on the palm-rest and keyboard assembly.
  8. At an angle, gently lift the palm-rest and keyboard assembly off the display assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\