Skip to main content
Contact Us

Dell Precision Optimizer Administrator’s Guide

PDF

Report settings

Enable system analysis

Table 1. Enable system analysisEnable system analysis option:
Attribute DetailDescription
Type:Enable or disable check box
Default:Disabled
Description:

This setting allows the DDV subsystem to start data collection. When disabled, DDV is not active. After enabling this option, DDV reports are generated periodically until the setting is manually turned off. Any change in this category selection should cause all existing DDV raw data to be discarded.

Generate report

Table 2. Generate reportGenerate report option:
Attribute DetailDescription
Type:

Select one of the following options:

  • After 24 hours (Daily)
  • After 12 hours
  • After 8 hours
  • After 6 hours
  • After 4 hours
Default:Daily
Description:

After enabling this option, DDV collects raw data and generates reports periodically. This setting controls how often the raw data is processed by DDV and converted into a new report. Any change in this category selection should cause all existing DDV raw data to be discarded.

Enable data collection

Table 3. Enable data collectionEnable data collection option:
Attribute DetailDescription
Type:

More than one category can be selected from the following:

  • Battery
  • Thermal
  • Fan
  • Processor
  • Memory
  • Storage
  • Network
Default:All check boxes are enabled
Description:

This setting allows the user to control which categories of data will be displayed in the report.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\