Dell Pro 14 PC14250 Owner's Manual

PDF

Installing the base cover

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the base cover and provide a visual representation of the installation procedure.
Figure 1. Connecting the battery cable
Image: Connecting the battery cable
Figure 2. Installing the base cover
Image: Installing the base cover
Figure 3. Installing the base cover
Image: Installing the base cover
NOTE:If you have disconnected the battery cable, ensure to connect the battery cable. To connect the battery cable, follow step 1 in the procedure.

Steps

  1. Connect the battery cable to the system board if the computer is not in service mode.
  2. Align the screw holes on the base cover with the screw holes on the palm-rest assembly and snap the base cover into place.
  3. Tighten the nine captive screws (M2.5x6) to secure the base cover to the palm-rest assembly.

Next steps

  1. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\