Dell Pro 14 PC14250 Owner's Manual

PDF

Installing the battery

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the battery and provides a visual representation of the installation procedure.
Figure 1. Installing the battery
Image: Installing the battery

Steps

  1. If the battery cable was removed for replacing the battery, you must transfer the battery cable from the old battery to the replacement battery. For more information, see Installing the battery cable.
  2. Align the screw holes on the battery to the screw holes on the palm-rest assembly.
  3. Tighten the four captive screws (M2x3) to secure the battery to the palm-rest assembly.
  4. Replace the screw (M2x4) that secures the battery to the palm-rest assembly.
  5. Connect the battery cable to the connector (BATT1) on the system board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\