Dell Pro 14 PC14250 Owner's Manual

PDF

Installing the camera

CAUTION:The information in this installation section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the camera and provides a visual representation of the installation procedure.
Figure 1. Installing the camera
Image: Installing the camera

Steps

  1. Align and place the camera module on the slot on the display back-cover.
  2. Connect the camera cable to the camera module and reattach the clip.

Next steps

  1. Install the display-panel assembly.
  2. Install the display bezel.
  3. Install the display assembly.
  4. Install the base cover.
  5. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\