Dell Pro 14 PC14250 Owner's Manual

PDF

Installing the display bezel

CAUTION:The information in this installation section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the display bezel and provide a visual representation of the installation procedure.
Figure 1. Installing the display bezel
Image: Installing the display bezel
Figure 2. Installing the display bezel
Image: Installing the display bezel

Steps

NOTE:The holding tape secures the camera shutter on the replacement display bezel.
CAUTION:To avoid accidental removal or damage to the camera shutter on the replacement display bezel, avoid peeling off the holding tape abruptly.

  1. Align and place the display bezel on the display assembly.
  2. Gently press along the edges of the display bezel to secure it with the clips on the display assembly.

Next steps

  1. Install the display assembly.
  2. Install the base cover.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\