Dell Pro 14 PC14250 Owner's Manual

Installing the display-panel assembly

CAUTION:The information in this installation section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the display panel and provide a visual representation of the installation procedure.

Image: Installing the display-panel assembly — Figure 1. Installing the display-panel assembly

Steps

NOTE:The display-panel assembly is preassembled with the display brackets as a single service part. Do not pull the Stretch Release tapes to separate the brackets from the display panel.

Place the display-panel assembly on a flat and clean surface.
Connect the display cable to the connector (LCD1) on the display-panel assembly and close the latch.
Adhere the conductive tape to secure the display cable to the display-panel assembly.
Insert the display-panel assembly tabs into the slots on the display cover.
Replace the four (M2.5x2.5) screws and four (M2.5x3.5) screws to secure the display-panel assembly to the display back cover.

Next steps

Install the display bezel.
Install the display assembly.
Install the base cover.
Follow the procedure in After working inside your computer.