Dell Pro 14 PC14250 Owner's Manual

PDF

Installing the eDP cable

CAUTION:The information in this installation section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the eDP cable and provides a visual representation of the installation procedure.
Figure 1. Installing the eDP cable
Image: Installing the eDP cable

Steps

  1. Connect the eDP cable to the connector (LCD1) on the camera module.
  2. Adhere the eDP cable to the display back cover.
  3. Adhere the conductive tape and route the eDP cable to the display back-cover.

Next steps

  1. Install the camera.
  2. Install the display-panel assembly.
  3. Install the display bezel.
  4. Install the display assembly.
  5. Install the base cover.
  6. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\