Dell Pro 14 PC14250 Owner's Manual

PDF

Installing the fan

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the fan and provides a visual representation of the installation procedure.
Figure 1. Installing the fan
Image: Installing the fan

Steps

  1. Place and align the screw holes on the fan with the screw holes on the system board.
  2. Replace the two screws (M2x3) that secure the fan to the system board.
  3. Connect the fan cable to the connector (FAN1) on the system board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\