Installing the I/O board (For computers
shipped with Intel Core Ultra 200U Series)
CAUTION:The information in this
installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the I/O board and provide a visual
representation of the installation procedure.Figure 1. Installing the I/O
board
Steps
Place and align the screw holes on the I/O board with the screw holes on the
palm-rest assembly.
Replace the three screws (M2x3) that secure the I/O board to the palm-rest
assembly.
Connect the vPro cable to the vPro connector on the I/O board.
Connect the I/O-board cable to the connector (IO) on the I/O board and close
the latch.
For computers shipped with fingerprint readers, connect the FPC cable of the
fingerprint reader to the connector (FPR) on the I/O board.
Gently press the right display-hinge in a downward direction towards the I/O
board.
Replace the two
screws (M2.5x5) that secure the
right display-hinge to the palm-rest assembly.
