Dell Pro 14 PC14250 Owner's Manual

PDF

Installing the keyboard support plate

CAUTION:The information in this installation section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the keyboard support plate and provide a visual representation of the removal procedure.
Figure 1. Installing the keyboard support plate
Image: Installing the keyboard support plate
Figure 2. Installing the keyboard support plate
Image: Installing the keyboard support plate

Steps

  1. Align the screw holes on the keyboard with the screw holes on the keyboard support plate.
  2. Replace the two screws (M2x2.2) screws that secure the keyboard to the keyboard support plate.

Next steps

  1. Install the keyboard.
  2. Install the power-adapter port.
  3. Install the system board (for computers shipped with Intel Core Series) or (for computers shipped with Intel Core Ultra 200U Series), whichever is applicable.
  4. Install the I/O board (for computers shipped with Intel Core Series) or (for computers shipped with Intel Core Ultra 200U Series), whichever is applicable.
  5. Install the display assembly.
  6. Install the heat sink.
  7. Install the fan.
  8. Install the wireless card.
  9. Install the SSD.
  10. Install the memory module.
  11. Install the battery.
  12. Install the base cover.
  13. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\