Dell Pro 14 PC14250 Owner's Manual

PDF

Installing the keyboard

CAUTION:The information in this installation section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the keyboard and provide a visual representation of the installation procedure.
Figure 1. Installing the keyboard
Image: Removing the keyboard
Figure 2. Installing the keyboard
Image: Installing the keyboard
Figure 3. Installing the keyboard
Image: Installing the keyboard

Steps

  1. Align the screw holes on the keyboard with the screw holes on the palm-rest assembly.
  2. Connect the keyboard cable and the keyboard backlit cable to the connectors on the touchpad.
  3. Replace the 22 screws (M2x2.2) that secure the keyboard to the palm-rest assembly.

Next steps

  1. Install the power-adapter port.
  2. Install the system board (for computers shipped with Intel Core Series) or (for computers shipped with Intel Core Ultra 200U Series), whichever is applicable.
  3. Install the I/O board (for computers shipped with Intel Core Series) or (for computers shipped with Intel Core Ultra 200U Series), whichever is applicable.
  4. Install the display assembly.
  5. Install the heat sink.
  6. Install the fan.
  7. Install the wireless card.
  8. Install the SSD.
  9. Install the memory module.
  10. Install the battery.
  11. Install the base cover.
  12. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\