Dell Pro 14 PC14250 Owner's Manual

PDF

Installing the palm-rest assembly (For computers shipped with smart card reader)

CAUTION:The information in this installation section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image shows the palm-rest assembly.
Figure 1. Installing the palm-rest assembly
Image: Installing the palm-rest assembly

Steps

Place the palm-rest assembly on a flat surface.
NOTE:The touchpad is part of the palm-rest assembly.

Next steps

  1. Install the keyboard.
  2. Install the power-adapter port.
  3. Install the system board (for computers shipped with smart card reader).
  4. Install the speakers.
  5. Install the power button.
  6. Install the I/O board (for computers shipped with Intel Core Series) or (for computers shipped with Intel Core Ultra 200U Series), whichever is applicable.
  7. Install the display assembly.
  8. Install the heat sink.
  9. Install the fan.
  10. Install the wireless card.
  11. Install the SSD.
  12. Install the memory module.
  13. Install the USH board.
  14. Install the smart card reader.
  15. Install the battery.
  16. Install the base cover.
  17. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\