CAUTION:The information in this
installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the power-adapter port and provide
a visual representation of the installation procedure. Figure 1. Installing the
power-adapter port
Steps
Align and place the power-adapter port on the system board.
Connect the power-adapter port cable to the connector (DCIN1) on the system
board.
Gently press the left display-hinge in a downward direction towards the
power-adapter port.
Replace the two screws (M2.5x4) that secure the
left display-hinge to the palm-rest assembly.
