Dell Pro 14 PC14250 Owner's Manual

PDF

Installing the power button with a fingerprint reader

CAUTION:The information in this installation section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

NOTE: For computers shipped without a fingerprint reader configuration, the power button installation steps remain the same.
The following images indicate the location of the power button and provide a visual representation of the installation procedure.
Figure 1. Installing the power button with a fingerprint reader
Image: Installing the power button with a fingerprint reader

Steps

  1. Align the screw holes on the power button to the screw holes on the palm-rest assembly.
  2. Replace the two screws (M2x2) that secure the power button to the palm-rest assembly.

Next steps

  1. Install the I/O board (for computers shipped with Intel Core Series) or (for computers shipped with Intel Core Ultra 200U Series), whichever is applicable.
  2. Install the fan.
  3. Install the base cover.
  4. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\