Dell Pro 14 PC14250 Owner's Manual

PDF

Installing the speakers (For computers shipped with smart card reader)

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

NOTE:If the rubber grommets are pushed out when removing the speakers, push them back in place before replacing the speakers.
The following images indicate the location of the speakers and provide a visual representation of the installation procedure .
Figure 1. Installing the speakers
Image: Installing the speakers

Steps

  1. Using the alignment posts, place the speakers into their slots on the palm-rest assembly.
    NOTE:Ensure that the rubber grommets are seated into the slot and installed on the speakers properly.
    Figure 2. Rubber grommets
    Image: Rubber grommets
  2. Route the speaker cables through the routing guides on the palm-rest assembly.
  3. Connect the speaker cable to the connector (SPK1) on the system board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\