Dell Pro 14 PC14250 Owner's Manual

PDF

Installing the USB Type-C module (For computers shipped with smart card reader)

CAUTION:The information in this installation section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the USB Type-C module and provide a visual representation of the installation procedure.
Figure 1. Installing the USB Type-C module
Image: Installing the USB Type-C module

Steps

  1. Place the USB Type-C module into the slot on the bottom side of the system board.
  2. Replace the three screws (M2x5) that secure the USB Type-C module in place.
  3. Turn the system board over.

Next steps

  1. Install the system board (for computers shipped with smart card reader).
  2. Install the display assembly.
  3. Install the heat sink.
  4. Install the fan.
  5. Install the wireless card.
  6. Install the SSD.
  7. Install the memory module.
  8. Install the battery.
  9. Install the base cover.
  10. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\