Dell Pro 14 PC14250 Owner's Manual

PDF

Installing the USH board FPC (For computers shipped with smart card reader)

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the USH board FPC and provides a visual representation of the installation procedure.
Figure 1. Installing the USH board FPC
Image: Installing the USH board FPC

Steps

  1. Connect the USH board FPC to the connector (C6613) on the system board.
  2. Connect the USH board FPC to the connector (CN661) on the USH board.
  3. Replace the protective film over the USH board.

Next steps

  1. Install the battery.
  2. Install the base cover.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\