Dell Pro 14 PC14250 Owner's Manual

PDF

Installing the vPro cable (For computers shipped with Smart card reader)

CAUTION:The information in this installation section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the vPro cable and provides a visual representation of the installation procedure.
Figure 1. Installing the vPro cable
Image: Installing the vPro cable

Steps

  1. Route the vPro cable through the routing guide on the palm-rest and keyboard assembly.
  2. Connect the vPro cable to the connector on the system board.
  3. Connect the vPro cable to the vPro connector on the I/O board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\