Dell Pro 14 PC14250 Owner's Manual

PDF

Removing the battery

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.

About this task

CAUTION:Removing the battery resets the BIOS setup settings to default. It is recommended that you note the BIOS setup settings before removing the battery.
The following image indicates the location of the battery and provides a visual representation of the removal procedure.
Figure 1. Removing the battery
Image: Removing the battery

Steps

  1. Disconnect the battery cable from the battery cable connector (BATT1) on the system board.
  2. Remove the screw (M2x4) that secures the battery to the palm-rest assembly.
  3. Loosen the four captive screws (M2x3) that secure the battery to the palm-rest assembly.
  4. Lift the battery off the palm-rest assembly.
  5. If you are replacing the battery, remove the battery cable to transfer it to the replacement battery. For more information, see Removing the battery cable.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\