Dell Pro 14 PC14250 Owner's Manual

PDF

Removing the camera

CAUTION:The information in this removal section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the display assembly.
  4. Remove the display bezel.
  5. Remove the display-panel assembly.

About this task

The following image indicates the location of the camera and provides a visual representation of the removal procedure.
Figure 1. Removing the camera
Image: Removing the camera

Steps

  1. Peel off the cable with adhesive backing, then pry detach the camera away from the display back-cover assembly.
  2. Remove the clip and disconnect the camera cable from the camera module.
  3. Lift the camera module off the display back-cover.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\