Dell Pro 14 PC14250 Owner's Manual

PDF

Removing the display back-cover assembly

CAUTION:The information in this removal section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the display assembly.
  4. Remove the display bezel.
  5. Remove the display-panel assembly.
  6. Remove the camera.
  7. Remove the eDP cable.

About this task

The following image shows the display back-cover assembly and provide a visual representation of the removal procedure.
Figure 1. Removing the display back-cover assembly
Image: Removing the display back-cover assembly

Steps

After performing the steps in the pre-requisites, we are left with the display back-cover assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\