Dell Pro 14 PC14250 Owner's Manual

Removing the display-panel assembly

CAUTION:The information in this removal section is intended for authorized service technicians only.

Prerequisites

Follow the procedure in Before working inside your computer.
Remove the base cover.
Remove the display assembly.
Remove the display bezel.

About this task

The following images indicate the location of the display-panel assembly and provide a visual representation of the removal procedure.

Image: Removing the display-panel assembly — Figure 1. Removing the display-panel assembly assembly

Steps

NOTE:The display-panel assembly is preassembled with the display brackets as a single service part. Do not pull the Stretch Release tapes to separate the brackets from the display panel.

Image: Display panel with support brackets

Remove the four (M2.5x2.5) screws and four (M2.5x3.5) screws that secure the left and right hinges to the display back cover.
NOTE:While removing the display-panel assembly, disengage the display panel tabs from the display cover before flipping it over.
Lift the lower portion of the LCD panel, slide it downwards, and then flip the panel over to access the display cable.
Peel the conductive tape on the display-cable connector.
Open the latch and disconnect the cable from the connector (LCD1) on the display panel.
Lift the display-panel assembly away from the display back cover.

Dell Pro 14 PC14250 Owner's Manual

Removing the display-panel assembly

Prerequisites

About this task

Steps

Rate this content