Dell Pro 14 PC14250 Owner's Manual

PDF

Removing the eDP cable

CAUTION:The information in this removal section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the display assembly.
  4. Remove the display bezel.
  5. Remove the display-panel assembly.
  6. Remove the camera.

About this task

The following image indicates the location of the eDP cable and provides a visual representation of the removal procedure.
Figure 1. Removing the eDP cable
Image: Removing the eDP cable

Steps

  1. Disconnect the eDP cable from the connector (LCD1) on the camera module.
  2. Peel away the conductive tape that adheres the eDP cable to the display back-cover.
  3. Lift the eDP cable away from the computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\