Dell Pro 14 PC14250 Owner's Manual

PDF

Removing the I/O-board FPC

CAUTION:The information in this removal section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the fan.

About this task

The following image indicates the location of the I/O-board FPC and provides a visual representation of the removal procedure.
Figure 1. Removing the I/O-board FPC
Image: Removing the I/O-board FPC

Steps

  1. Open the latch and disconnect the I/O-board FPC from the connector (IO) on the I/O board.
  2. Open the latch and disconnect the other end of the I/O-board FPC from the connector on the system board.
  3. Slide and lift the I/O-board FPC cable off the computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\