Dell Pro 14 PC14250 Owner's Manual

PDF

Removing the power-adapter port

CAUTION:The information in this removal section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.

About this task

The following images indicate the location of the power-adapter port and provide a visual representation of the removal procedure.
Figure 1. Removing the power-adapter port
Image: Removing the power-adapter port

Steps

  1. Remove the two screws (M2.5x5) that secure the left display-hinge to the palm-rest assembly.
  2. Lift the left display-hinge upward to access the power-adapter port.
  3. Disconnect the power-adapter port cable from the connector (DCIN1) on the system board.
  4. Remove the power-adapter port from the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\