Dell Pro 14 PC14250 Owner's Manual

PDF

Removing the power button with a fingerprint reader

CAUTION:The information in this removal section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the fan.
  4. Remove the I/O board (for computers shipped with Intel Core Series) or (for computers shipped with Intel Core Ultra 200U Series), whichever is applicable.

About this task

NOTE: For computers shipped without a fingerprint reader configuration, the power button removal steps remain the same.
The following images indicate the location of the power button and provide a visual representation of the removal procedure.
Figure 1. Removing the power button with fingerprint reader
Image: Removing the power button with a fingerprint reader

Steps

  1. Remove the two screws (M2x2) that secure the power button to the palm-rest assembly.
  2. Lift the power button from the slot in the palm-rest assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\