Dell Pro 14 PC14250 Owner's Manual

PDF

Removing the solid state drive (SSD)

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.

About this task

NOTE:The procedures in this section apply only to computers shipped with a solid state drive (SSD). For computers shipped with UFS, the storage is integrated with the system board. Dell Technologies recommends that you back up your data regularly to avoid any potential data loss after a service incident. For more information, see the knowledge base article 000130154 at Dell Support Site.
The following image indicates the location of the solid state drive (SSD) and provides a visual representation of the removal procedure.
Figure 1. Removing the SSD
Image: Removing the SSD

Steps

  1. Remove the screw (M2x3) that secures the SSD to the system board.
  2. Slide and remove the SSD from the M.2 slot on the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\